Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
38mm CTI "wildman" nose cone
#1
Hi all, stupid question here. the new nosecones wildman and others are selling, how do you attach a harness to these? 
When Tim first started selling them he said to grind a groove on the inside of the shoulder then epoxy some kevlar in place. Well i tried that and even jbweld and the strap wont stay!
I should mention this is the 38mm molded version..

anyone have photos of how they are keeping the strap attached??

Thanks in Advance


Bill Clune L3 | NAR#88583
Been a launch Director
Founded a Club
MARS Club|SRC|MDRA - Forever
Reply
#2
I used this nose cone for my 38mm MD build (http://rocketrycenter.com/showthread.php?tid=219). I don't have a picture of shock cord attachment, but I can get one when I'm back home later. I used some CA glue and poured it into the tip and stuck the shock cord into that. Once that dried I poured some west systems 105/205 on top of that and let that cure. The only way it's coming out is if it snaps.

NAR# 98194
Level 1: CTI I-216, 3,043'
Level 2: CTI K-740, 5,999'

Personal altitude record: 12,400' CTI L395
2014 total impulse: 9,018.2 Ns (76% M)
2015 total impulse: 7,171.7 Ns (40% M)
2016 total impulse: 18,664.2 Ns (91% N)
2017 total impulse: 8,281.1 Ns (80% M)
Reply
#3
When I did mine, I just sanded well and JB welded sort of how you describe. Works for me.
Cody Smith
NAR: Jr. L1
TRA: TMP
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)