Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tips for 3D printed Nosecones..
#6
I haven't run the hot-car test on a PETG part yet. In theory, it has a higher Tg than PLA. It's warping is sort of similar to PLA. It has no nasty odor when printing. The only downsides I have found to the stuff are that (a) it seems a bit stringy (needs more retraction on moves) and (b) is difficult to obtain in the colors I want.
NAR #96751, Level 2
Mayhem Rocketry, LLC
That's a nice rocket you have there...if you're looking for me, I'll be under my car.
Reply


Messages In This Thread
Tips for 3D printed Nosecones.. - by K'Tesh - 07-11-2015, 03:25 AM
RE: Tips for 3D printed Nosecones.. - by hcmbanjo - 07-11-2015, 10:40 AM
RE: Tips for 3D printed Nosecones.. - by Etoyoc - 07-11-2015, 11:28 AM
RE: Tips for 3D printed Nosecones.. - by wfcook - 07-15-2015, 05:04 PM
RE: Tips for 3D printed Nosecones.. - by Etoyoc - 07-15-2015, 09:21 PM
RE: Tips for 3D printed Nosecones.. - by wfcook - 07-15-2015, 11:22 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)